
EEC-V powertrain control module (PCM) has a 104-pin connector and in this page, you'll find the circuit description of each of those pins.
If you take a look at the backside (wire side) of the EEC-V PCM's 104-pin connector, you're going to see that there are some numbers embossed on the connector itself, and these numbers will help you correctly identify the pins you need to test.
APPLIES TO: The PCM connector pinout applies only to the following Overhead Valve (OHV) non-DOHC and non-Flex Fuel vehicles:
- 3.0L V6 (OHV) Ford Taurus: 2000.
- 3.0L V6 (OHV) Mercury Sable: 2000.
WIRE COLOR LEGEND/ID:
PCM LOCATION AND TESTING TIPS:
- EEC-V PCM Location (2000 3.0L V6 Ford Taurus, Mercury Sable).
- How To Safely Probe The PCM Connector -Without Damaging It (1991-2007 3.0L V6 Ford Taurus, Mercury Sable).
104 Pin PCM Connector Pinout | ||
---|---|---|
Pin | Wire Color | Description |
1 | VIO/ORG | Shift Solenoid #2 (SS2) |
2 | PNK/LT GRN | Malfunction Indicator Lamp (MIL) Control |
3 | YEL/BLK | Digital Transmission Range (DTR) Sensor (TR 1) |
4 | – | NOT USED |
5 | WHT/ORG | Secondary Air Injection Relay (AIR INJ RLY) |
6 | DK GRN/WHT | Turbine Shaft Speed (TSS) Sensor |
7 | – | NOT USED |
8 | – | NOT USED |
9 | YEL/WHT | Fuel Gauge Sender |
10 | – | NOT USED |
11 | – | NOT USED |
12 | WHT/LT GRN | Check Transaxle Temp |
13 | VIO | Module Programming Signal |
14 | – | NOT USED |
15 | PNK/LT BLU | SCP Bus (–) –Data Link Connector |
16 | TAN/ORG | SCP Bus (+) –Data Link Connector |
17 | BRN/YEL | RX Signal –Passive Anti-Theft Transceiver Module |
18 | GRY/RED | TX Signal –Passive Anti-Theft Transceiver Module |
19 | – | NOT USED |
20 | – | NOT USED |
21 | GRY | Crankshaft Position (CKP) Sensor |
22 | DK BLU | Crankshaft Position Sensor Return (CKP RTN) |
23 | – | NOT USED |
24 | BLK/WHT | Ground (GND) |
25 | BLK | Ground (GND) |
26 | YEL/BLK | Ignition Coil A –Cylinders 1 And 5 Spark Control |
27 | ORG/YEL | Shift Solenoid A (SHIFT SOL A) |
28 | LT BLU | Low Fan Relay Control |
29 | – | NOT USED |
30 | DK BLU/LT GRN | Anti-Theft Indicator Input |
31 | – | NOT USED |
32 | YEL | Knock Sensor |
33 | – | NOT USED |
34 | – | NOT USED |
35 | RED/BLK | Heated Oxygen Sensor #12 (HO2S 12) Input (Catalyst Monitor) |
36 | TAN/LT BLU | Mass Air Flow Sensor Return (MAF RTN) |
37 | ORG/BLK | Transmission Fluid Temperature (TFT) Sensor Input |
38 | LT GRN/RED | Engine Coolant Temperature (ECT) Sensor Input |
39 | GRY | Intake Air Temperature (IAT) Sensor Input |
40 | DK GRN/YEL | Fuel Pump Monitor (FPM) |
41 | DK GRN/WHT | A/C High Pressure Switch Input |
42 | – | NOT USED |
43 | – | NOT USED |
44 | PNK | Starter Relay Control |
45 | – | NOT USED |
46 | LT GRN/VIO | High Speed Fan Relay Control |
47 | BRN/PNK | EGR Vacuum Regulator (EVR) Control |
48 | TAN/YEL | Tachometer (TACH) |
49 | LT BLU/BLK | Digital Transmission Range (DTR) Sensor (TR 2) |
50 | WHT/BLK | Digital Transmission Range (DTR) Sensor (TR 4) |
51 | BLK/WHT | Power Ground (PWR GND) |
52 | YEL/RED | Ignition Coil B –Cylinders 3 And 4 Spark Control |

53 | PNK/BLK | Shift Solenoid C (SHIFT SOL C) |
54 | VIO/YEL | Torque Converter Clutch (TCC) Solenoid |
55 | PNK/LT BLU | Power (PWR) B+ |
56 | GRY/YEL | (EVAP) Canister Purge Solenoid |
57 | YEL/RED | Knock Sensor |
58 | – | NOT USED |
59 | – | NOT USED |
60 | GRY/LT BLU | Heated Oxygen Sensor #11 (HO2S 11) Input |
61 | VIO/LT GRN | Heated Oxygen Sensor #22 (HO2S 22) (Catalyst Monitor) |
62 | RED/PNK | Fuel Tank Pressure (FTP) Sensor |
63 | WHT/YEL | Electronic Pressure Control Solenoid (EPC SOL) |
64 | RED/BLK | Digital Transmission Range (DTR) Sensor (TR 3) |
65 | BRN/LT GRN | Differential Pressure Feedback EGR (DPFE) Sensor Input |
66 | – | NOT USED |
67 | VIO/WHT | EVAP Canister Vent Solenoid |
68 | GRY/BLK | Vehicle Speed Sensor (VSS) |
69 | PNK/YEL | A/C Clutch Relay Control |
70 | BRN | Electric Air Management (EAM) Relay |
71 | RED | Power (VPWR) |
72 | – | NOT USED |
73 | TAN/BLK | Fuel Injector #5 Control |
74 | BRN/YEL | Fuel Injector #3 Control |
75 | TAN | Fuel Injector #1 Control |
76 | BLK/WHT | Ground (GND) |
77 | BLK/WHT | Ground (GND) |
78 | YEL/WHT | Ignition Coil C –Cylinders 2 And 6 Spark Control |
79 | WHT/LT GRN | Check Transmission Indicator Lamp |
80 | LT BLU/ORG | Fuel Pump (FP) Control |
81 | BRN/ORG | Electronic Pressure Control (EPC) Solenoid |
82 | – | NOT USED |
83 | WHT/LT BLU | Idle Air Control (IAC) Valve Control |
84 | DK BLU/YEL | Output Shaft Speed (OSS) Sensor |
85 | DK BLU/ORG | Camshaft Position (CMP) Sensor Input |
86 | BLK/YEL | A/C Clutch Relay Switched Output |
87 | RED/LT GRN | Heated Oxygen Sensor #21 (HO2S 21) Input |
88 | LT BLU/RED | Mass Air Flow (MAF) Sensor Input |
89 | GRY/WHT | Throttle Position (TP) Sensor Input |
90 | BRN/WHT | Reference Voltage (REF VOLT) |
91 | GRY/RED | Signal Return (SIG RTN) |
92 | RED/LT GRN | Brake Pedal Position (BPP) Switch Input |
93 | RED/WHT | Heated Oxygen Sensor #11 (HO2S 11) Heater Control |
94 | WHT/BLK | Heated Oxygen Sensor #21 (HO2S 21) Heater Control |
95 | YEL/LT BLU | Heated Oxygen Sensor #12 (HO2S 12) Heater Control (Catalyst Monitor) |
96 | TAN/YEL | Heated Oxygen Sensor #22 (HO2S 22) Heater Control (Catalyst Monitor) |
97 | – | NOT USED |
98 | – | NOT USED |
99 | LT GRN/ORG | Fuel Injector #6 Control |
100 | BRN/LT BLU | Fuel Injector #4 Control |
101 | WHT | Fuel Injector #2 Control |
102 | – | NOT USED |
103 | BLK/WHT | Power Ground (PWR GND) |
104 | – | NOT USED |
WIRE COLOR LEGEND: You can find the wire color legend here: Connector Wire Color Legend (1991-2007 3.0L V6 Ford Taurus, Mercury Sable).

Relate PCM Connector Pinouts
- EEC-IV 60-PIN PCM Connector Pin Out Chart (1991-1992 3.0L V6 Ford Taurus, Mercury Sable).
- EEC-IV 60-Pin PCM Connector Pin Out Chart (1993-1995 3.0L V6 Ford Taurus, Mercury Sable).
- EEC-V 104-Pin PCM Connector Pin Out Chart (1996 3.0L V6 Ford Taurus, Mercury Sable).
- EEC-V 104-Pin PCM Connector Pin Out Chart (1997-1998 3.0L V6 Ford Taurus, Mercury Sable).
- EEC-V 104-Pin PCM Connector Pin Out Chart (1999 3.0L V6 Ford Taurus, Mercury Sable).
Disclaimer
I've made every effort to double and triple check the above info (and in the next couple of pages) and I've used the best sources to compile it but nothing in life is perfect. I don't have a staff of proof readers or editors, I'm just a little guy typing this stuff up in my spare time to help and give back to the Do-It-Yourself community. So without further ado, here's my disclaimer:
© copyright Abraham Torres-Arredondo: This information is distributed in the hope that it will be useful, but WITHOUT ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.

If this info saved the day, buy me a beer!
